Fender Superstrat HH Wiring Harness with Coil Split and Out of Phase

Description

Fender Superstrat HH Wiring Harness with Coil Split and Out of Phase

To fit models with a 2 x Humbuckers.

This pre-wired Fender Superstrat HH Wiring Harness with Coil Split and Out of Phase is designed for replacing old electrics or upgrading the electronics of imported models or for use on DIY Kits. We take a massive amount of care and attention when putting our Fender Superstrat HH Wiring Harnesses together. Everything is fully tested before being posted to you.

This is a Professional Fender Superstrat HH Wiring Harness using the very best in components to enhance the quality of tone and sound output from your guitar.

Components
USA 500k CTS Push & Pull Potentiometer x 3, Split Shaft.
Oak Grigsby 3 Way Lever Switch.
Switchcraft USA Jack Socket.
Sprague Orange Drop Capacitor x 1, Size 0.022uF.
Gavitt USA Cloth Covered 22AWG wire.
Tinned-Copper “Buss” Ground Wire.
Mounted on a 3D Printed Wiring Template.
Jack Socket and Pots supplied with Nut, Flat Washer & Locking Star Washer.
You are welcome to Contact Us with your custom requirements.

Controls
Bridge Volume Control with Coil Split.
Neck Volume Control with Coil Split.
Master Tone Control with Out of Phase.

Switching
Position 1 – Bridge Pickup
Position 2 – Bridge & Neck Pickup
Position 3 – Neck Pickup

Will this fit my guitar?
Our pre-wired Fender Superstrat HH Wiring Harness is wired to fit genuine Fender USA or Mexican control plates. If installing into an imported model or a DIY guitar kit you will need to ensure the Potentiometer holes on the Pickguard will take CTS pots (approx 10mm). This can be done using a round file or carefully with a 10mm drill.

Centre to centre measurements between components
Centre of Switch to bridge volume pot – 48mm.
Centre of bridge volume pot to centre of neck volume pot 1 – 45mm.
Centre of neck volume pot to centre of tone pot – 45mm.
These measurements were taken from a USA / Mexican Fender Stratocaster pickguard.

Installation, Wiring Diagram and Support
Please see our Support Page for wiring diagrams and fitting instructions.
We have made it as simple as possible to install your Fender Superstrat HH Wiring Harness with Coil Split and Out of Phase with a fitting guide and simple to follow wiring diagram.
We also offer full support should you need it.

Order Times
We make everything to order and the turnaround time for a Fender Superstrat HH Wiring Harness with Coil Split and Out of Phase is 48 hours.

Fender Superstrat HH Wiring Harness with Coil Split and Out of Phase