Gibson & Epiphone Les Paul Active Wiring Harness (Soldered)
This pre-wired Gibson & Epiphone Les Paul Active Wiring Harness for “active pickups” is perfect for replacing “solderless” systems or upgrading your current passive system to active. We take a massive amount of care and attention when putting our Les Paul harnesses together. Everything is fully tested before being posted to you.
Read about our Vintage Wiring Harnesses here >. We use our Les Paul Active wiring harnesses in our workshop for our clients guitar upgrades and also for our Axeify guitar upgrading services, read more here >
Bourns 25k Potentiometers x 4 (Long shaft fitted with additional nut for height adjustment)
Sprague Orange Drop 0.1uf Capacitors x 2
20AWG Tinned copper ground
You are welcome to contact us with your custom requirements.
Volume 1 – Bridge
Volume 2 – Neck
Tone 1 – Bridge
Tone 2 – Neck
Will this fit my guitar?
Our pre-wired Les Paul Active Wiring harness is wired into genuine Gibson & Epiphone models.
Centre to centre measurements between components
Centre of neck volume pot and neck tone pot – 63mm
Centre of neck volume pot and bridge volume pot – 50mm
Centre of neck tone pot and bridge tone pot – 50mm
Centre of bridge volume pot and bridge tone pot – 61mm
Measurements can sometimes vary slightly on some Les Paul models, so we allow plenty of movement in wire lengths between components to allow for a comfortable fit. If your measurements are different from the above, please let us know and we will build your harness to your specifications.
Installation, Documents & Support
We have made it as simple as possible to install your Gibson & Epiphone Les Paul Active Wiring Harness with a fitting guide and simple to follow wiring diagram included with your purchase. We also offer full support should you need it.
We make everything to order and the turnaround time for a Gibson / Epiphone Les Paul Active Wiring Harness is 48 hours.